[. . . ] Do not wipe the product with a wet towel and do not use any heater or humidifier below where the product is installed. If water flows into the product or if moisture and heat are applied to the product, it can cause a fire, an electric shock or problem to the product. When drilling holes in the wall, always use a drill bit and drill of designated diameter. Also follow the designated directions for the depth of the hole. If the product is installed without following the designated method, the product may be unstable and cause a safety issue. Do not install the product near any object that may cause vibration. Do not install the product near any high voltage power cable or power source. Unplug the power cord from the power outlet before installing the product. If you install the product with the power cord plugged, it can cause an electric shock or a fire. Do not install the product with bare hands. [. . . ]  Assemble the guide spacers to the set by tightening the screws as shown in the picture. Use a Phillips head "+" driver (Manual or motorized) to tighten the screws. Tighten each screw until the set, guide spacer, and the screw are fully pressing against one another. 2 How to attach to masonry walls Please follow the directions below. - Check the material and thickness of the wall. -  hen installing the product on wall material not designated, install the product so that each screw location can W withstand the pull out load of 70 kgf (686 N) and shear load of 100 kgf (980 N) or above. Anchor a b c Wall mount screw d e - Use an Ø8 mm drill bit for concrete and hammer (Impact) drill. Use an Ø8 mm drill bit to drill a hole for the anchor location within a depth of 80 mm - 100 mm b.  et the wall mount on the wall by aligning to the location of the hole. Then, fasten the bolts at torque of 45 kgf/cm - 60 kgf/cm. 4 <When installing on a masonry wall> → f it’s not possible to use the indicated bolt holes, use I  the closet ones. → Use a Phillips head "+" driver (Manual or motorized)  or 8 mm wrench to tighten the screws. Tighten each screw until the set, guide spacer, and the screw are fully pressing against one another. Wall mount screw h w <When mounting to wooden studs> 76 mm drywall 406 m m wood stud drywall an a.  fter aligning the wall bracket on the wall where the center of the wood stud is marked, mark the location of the screws and A then remove the wall bracket. Use the Ø4 mm drill bit for wood to drill holes with the depth of 76 mm or above where the wall mount screw location is  marked on the wall. Tighten the wall mount screws for the wall bracket on the drilled hole. →  t this time, tighten the screw so that the wall, wall bracket and the wall mount screw are pressed against one another. [. . . ] Use some type of cable banding device to hold all the cables  together. -  ttach the set protection cushions to mitigate any impact between the wall and the set. [. . . ]